Get shopping advice from experts friends and the community.
Dryer thermal cutoff fuse keeps blowing.
I had a friend with a non working clothes dryer give me a call turns out it was just a bad thermal fuse.
I have a kenmore elite he4 electric dryer model number 11085872400.
With the fuse out the element still gets heated but the dryer doesn t spin.
When the fuse blows the dryer won t get hot but when the.
I checked and have no obstructions in the short line outside 5 duct run is all i have and have replaced the cycling thermostat that should prevent the temperature from getting high enough to fail the thermal fuse.
My samsung dryer kept blowing the thermal fuse.
Again i replaced the fuse thinking there was something wrong with the fuse and it worked for a good 20 mins and stopped.
The thermal cutoff is located on the heater assembly and it controls the temperature of the dryer.
The thermal cutoff isn t the same as a thermal fuse.
Thermal cutoff hi limit and thermistor test fine heating element has continuity but no resistance venting is clear.
Whirlpool kenmore electric dryer keeps blowing thermal fuse.
I have a whirlpool electric dryer that keeps blowing the thermal fuse at the vent outlet.
The thermal fuse on my inglis maytag dryer keeps blowing.
I replaced the fuse and the dryer worked for a good 30 mins and then it stopped.
I tested the dryer and it heated right up.
Temporarily tape the two wires that go to the thermal fuse together to essentially bypass or jump the thermal fuse.
Use electrical tape to properly insulate the connection and avoid contact of bare wire contacts with the dryer cabinet.
What it finally turned out to be was the samsung dc96 00882c dryer idler pulley.
Thermal cutoff heater assembly fuse keeps tripping.
The fuse controls the dryer s heating element whereas the cutoff controls the motor.
Unplug the dryer to disconnect electrical power.
Before replacing the thermal fuse again try these steps.
If you notice that the drum spins but there s no heat produced the thermal cutoff switch is probably blown.
I attempted to dry another load of clothes and it didn.
It also helps monitor the amount of heat being produced by the dryer.
A groove opening somehow got worn into it.
I found the problem to be the thermal cut off and replaced that part.
Heating element turn read more.
